Filter
Top Products
NSR-1000 Series v1.1.1 Release Note
set up masks again. (V1
1R:484)
４-１-９ Server Configuration
・ Pay attention to the foll
owings when you want to change the recording storage
from default to other in the storage settings. It affects the estimation of storage
capacity.
When the storage mode is put into the camera mode (refer to “Configuring
Storage for Each camera ([Camera] mode) in the User’s Guide, for details.),
audio data is saved in default storage even if changing the recording storage
from default.
When the storage mode is put into the recording type mode (refer to
“Configuring Storage for Each recording type ([Recording Type] mode) for
details.), audio and image data are saved in the specified and same storage.
(V11R:272)
４-１-１０ Action Configuration
・ When
configuring a beep tone so that it sounds by being triggered by the
schedule, the beep sounds briefly and it is hard for an operator to notice it.
When you want to know the trigger occurrence for certain, configure the alarm
recording and confirm the trigger occurrence in the alarm history. (V11N:107)
４-１-１１ Schedule Configuration
・ When
the scheduled recording is configured for the cameras or camera servers
listed below, recording starts a few seconds behind the scheduled time.
(V11R:638)
SNC-RH series
SNC-RS series
SNT-EP series
SNT-EX series
・ When a load of disk writing is very high in a server, an alarm recording stops
shorter than estimated in rare cases. Please set a record duration longer.
(V11R:759, V11N:543)
- 25 -