Filter
Top Products
NSR-1000 Series v1.1.1 Release Note
internal value not to over the limita
tion. (V11N:335)
・ Regarding following ca
meras, if user use the VMD (Camera) with the codec as
MPEG4, the frame rate is limited as 20FPS with NTSC or 16FPS with PAL. If
VMD (Camera) is disabled after enabled, maximum frame rate setting becomes
available after other resolutions are selected once. (VT1:2016)
SNC-RZ50, SNC-CM120, SNC-CS50, SNC-CS20, SNC-DM160, SNC-DM110,
SNC-DS60, SNC-DS10, SNC-DF85, SNC-DF80, SNC-DF50, SNC-RX570,
SNC-RX550, SNC-RX530
・ When you configure masks for a camera which is now recording images, the
mask area shifts as expected for the live images, however, recording continues
with the original mask setting at the beginning of recording. To enable the
mask function in recording, be sure to deselect the [Enable] check box to enable
the schedule on the Record dialog box, and then select it to apply. (VT3:830)
・ When you do the Automatic Alarm Schedule Configuration, schedule is
configured with the setting in [Video] tab. (VT1:2068)
・ Note that some cameras do not support the camera direct panning/tilting
function and area zoom function. If you use the encoder together with the
cameras, check the manual to see if the cameras to be used support the above
functions. (VT2:776)
・ There are some restrictions when H.264 is selected for the cameras below:
SNC-CS50, SNC-DF50, SNC-DF80, SNC-DF85,
SNC-RX530, SNC-RX550, SNC-RX570, SNC-RZ50
・ Another codec cannot be selected at the same time.
・ VMD(Camera) and VMF function does not work despite those settings are
available in the [VMD] tab of the configuration screen. Please use the
VMD(Recorder) when H.264 is selected.
- 12 -