Filter
Top Products
NSR-1000 Series v1.1.1 Release Note
window
, a space can not be used in the Preset name. (VT1:1960)
・ When VMD(Camera) is configured to SNT-V704, the detection area is created
as QVGA size even though the detection area is configured as the full screen of
the monitor frame. (VT1:2032)
・ When the multiple cameras are selected in Device configuration, all the sensor
input/output pins of the selected cameras are shown instead of the common
sensor input/output pins among the selected cameras. (VT1:2089)
・ In case of JPEG codec, the Monitoring Framerate might be the same value as
the Recoding Framerate even though the Monitoring Framerate is more than
the Recording Framerate. (VT1:2183)
・ Only “All” can be selected by the selection of the network on the easy
registration setting screen when used in German. (VT1:2241)
・ On the [Video] tab of AXIS camera and encoder, if user changes one of the three
configurations (Schedule Record, Alarm/Event Record, Monitoring) of codec,
other two configurations of codec are not automatically changed. When these
settings of codec are not the same, the codec of "Monitoring" is used for
recording. (VT1:1917)
・ Note that some cameras do not support the camera direct panning/tilting
function and area zoom function. If you use the encoder together with the
cameras, check the manual to see if the cameras to be used support the above
functions. (VT1:2013)
５-２-２-５ Layout Configuration
・ GUI may abend in case that user adds a layout
without pushing "Apply" in the
layout tour and after that user push "Apply" button with changing the sequence
of layouts in the tour. (VT1:2245)
- 40 -