Filter
Top Products
15
Attenuating the sound
Press (ATT) on the supplied rotary
commander or card remote commander.
“ATT on” lights up for a second.
To restore the previous volume level, press
(ATT) again.
Tip
The unit decreases the volume automatically when
a telephone call comes in (Telephone ATT
function).
To increase
To decrease
Press (SOUND) to
adjust the volume
and sound menu.
Press (LIST) to:
• Display the memorized names.
• Display the programme type.
Adjusting the sound
characteristics
You can adjust the equalizer curve, listening
position, cut-off frequency, bass, treble,
balance, and fader.
You can store the bass and treble levels
independently for each source.
1 Select the item you want to adjust by
pressing (SOUND) repeatedly.
VOL (volume) n EQ (equalizer curve)* n
POS (listening position)* n SUB
(subwoofer volume) n CNW (Crossover
Network)* n BAS (bass) n TRE (treble)
n BAL (left-right) n FAD (front-rear)
* If the corresponding optional equipment is
not connected, this item will not appear.
2 Adjust the selected item by rotating the
dial.
Adjust within three seconds after selecting
the item. (After three seconds, the dial
function reverts the volume control.)
Changing the operative direction
The operative direction of controls is factory-
set as shown below.
If you need to mount the rotary commander on
the right hand side of the steering column, you
can reverse the operative direction.
Press (SOUND) for two seconds while
pushing the VOL control.
Tip
You can also change control the operative
direction of these controls with the unit. (See
“Changing the sound and display settings” on
page 16.)