Filter
Top Products
OWNER’S MANUAL ENGLISH
10
LW5.830
+12V REM GND
-
BRIDGED
-
+
-
+
BRIDGED
-+-+
SUB
+
SUB
..
.. ..
..
..
..
-
+
-
+
-
+
-
+
HI INPUT
HI INPUT
MIN MAX
GAIN LPF HPF
MIN MAX
50Hz - 650Hz
50Hz - 650Hz
50Hz - 650Hz
50Hz - 650Hz
LOW 50Hz-650Hz
HIGH 500Hz - 6.5KHz
LOW
50Hz-
650Hz
HIGH
500Hz -
6.5KHz
12dB
6dB
0dB
..
MIN MAX
..
50Hz - 250Hz
..
..
0dB 18dB
0° 180°
GAIN LPF HPF
LPF
HPF
BPF
FULL
CH3/CH4
CH1/CH2
LPF
HPF
FULL
12dB
6dB
0dB
PWR/PRT
SUB
PHASE CH3 CH1
CH4 CH2
SUB
ON OFF
Power Terminal:
Connect heavy (2 gauge / 35 sqmm)
stranded wire to the 12 volt and
grounded source. Connect the
ground to the chassis near the amp
Connenct Remote Turn On wire
from source unit with the REM input
Speaker Output:
Left and right speaker connections.
Use Left Positive (+) and Right
Negative (-) for bridged output
Subwoofer Output (CH 5):
Use SUB only for a
subwoofer operation
High Inputs CH 1/2:
High Level Input from source
unit via speaker output
INPUTS & CONTROLS
RCA Input CH 1/2 & CH 3/4:
Input from source unit
via Cinch/RCA output
Crossover-Switch CH 1/2 & 3/4:
Low Pass Filter /
Full Range Mode /
High Pass Filter /
Band Pass Filter (only CH 3/4)
High Inputs CH 3/4:
High Level Input from source
unit via speaker output
Low Pass Filter (LPF) CH 1/2 & 3/4:
Frequency adjustment 50 Hz to 650 Hz
High Pass Filter (HPF) CH 1/2 & 3/4:
Frequency adjustment
50 Hz to 650 Hz
Gain Control:
Used to adjust gain
to match source unit
Bass Boost CH 1/2 & 3/4:
Switch 0 /+6 /+12dB
Bass Boost CH 5:
Adjust Bass Boost 0 – 18dB
Subwoofer Switch (SUB on/off):
Activates CH 5 for subwoofer mode
Phase Shift:
Adjust the acoustic Phase
Shift from 0 – 180°
Low Pass Filter (LPF):
Freq. adjustment
50 to 250 Hz
Power LED:
Green: power on
Red: protection mode
Frequency Range (HIGH/LOW)
for Bandpass-Mode (BP):
Switch frequency from
50 Hz to 650 Hz (LOW) or from
500 Hz to 6.5 kHz (HIGH) on CH 3/4
Fuses (located inside):
Never replace with a fuse
greater than specified
Please observe speaker channel and polarity as printed by the speaker terminal block.
Incorrect phasing of the speakers results in total loss of bass response.
CAUTION:
Please never use the RCA/Cinch Inputs and the High Level Inputs at the same time.
Otherwise your amplifier will get damaged.
CAUTION: