Filter
Top Products
OWNER’S MANUAL ENGLISH
6
INPUTS & CONTROLSLW2.240
L
R
GAIN LPF HPF
BASS
BOOST
MIN
MAX
HI INPUT
50Hz - 650Hz50Hz - 650Hz
LPF
FULL
HPF
BPF
50Hz-650Hz
LOW
HIGH
500Hz - 6.5KHz
- +
- +
PWR/PRT
12dB
6dB
0dB
.. .. ..
+
+
- -
BRIDGED
+12V REM GND
Power Terminal:
Connect heavy (8 gauge / 10 sqmm)
stranded wire to the 12 volt and
grounded source. Connect the
ground to the chassis near the amp
Connenct Remote Turn On wire
from source unit with the REM input
RCA Input L / R:
Input from source unit
via Cinch/RCA output
High Input L / R:
High Level Input from source
unit via speaker output
Low Pass Filter (LPF):
Frequency adjustment
50 Hz to 650 Hz
High Pass Filter (HPF):
Frequency adjustment
50 Hz to 650 Hz
Bass Boost:
Switch 0 /+6 /+12dB
Gain Control:
Used to adjust gain
to match source unit
Crossover-Switch:
Low Pass Filter /
Full Range Mode /
High Pass Filter /
Band Pass Filter
Power LED:
Green: power on
Red: protection mode
Frequency Range (HIGH/LOW)
for Bandpass-Mode (BP):
Switch frequency from
50 Hz to 650 Hz (LOW) or from
500 Hz to 6.5 kHz (HIGH)
on Channel L/R
Speaker Output:
Left and right speaker
connections. Use Left Positive (+)
and Right Negative (-) for
bridged output
Fuse:
Never replace
with a fuse greater
than specified
Please never use the RCA/Cinch Inputs and the High Level Inputs at the same time.
Otherwise your amplifier will get damaged.
CAUTION:
Please observe speaker channel and polarity as printed by the speaker terminal block.
Incorrect phasing of the speakers results in total loss of bass response.
CAUTION: