Filter
Top Products
Any tracks that have a smaller latency than the maximum
must also be delayed but by a smaller amount (i.e. tracks
with 1 Duende plug-in where the maximum has 3). The
delay value for these will be maximum latency minus the
latency reported by that track.
Using Automatic Delay Compensation in Pro Tools HD
Pro Tools HD users have the luxury of being able to use
Automatic Delay Compensation, as opposed to the manual
method required in Pro Tools LE and M-Powered. However,
there are still some considerations to be taken into account to
make sure all Duende plug-ins are compensated for and
everything stays perfectly in sync.
To turn on ADC, go to ‘Setup>Playback Engine’ whilst Pro
Tools is stopped and you will see a box labeled ‘Delay
Compensation Engine’. Change the setting here to ‘Long
(4095 Samples per channel)’.
Pro Tools will then tell you that it will close and re-open your
session after clicking the OK button in the dialogue box;
therefore make sure you have saved your session prior to
doing this. Also put the CPU usage limit to 85%.
Pro Tools will now automatically compensate for any
introduced latency of 4095 samples or less.
10