Filter
Top Products
Page 8
Removing the Detachable Speaker Module
This model is shipped with the speaker module attached to the TV. Follow these instructions if, for any reason, you wish to remove
the speaker module.
Tools Needed: Phillips screwdriver, Plastic Plug that is packaged in the Operator’s
Manual plastic envelope.
Note: If you plan to mount the TV on the Table Stand or wall mount,
it is best to remove the Detachable Speaker Module rst.
1. Prepare a at work surface, free of any debris or items which may scratch the
front surface of the TV.
2. Lay the TV face-down on the work surface with the bottom of the unit closest
to you
3. Position the TV so that the bottom edge overhangs the table by about one
inch.
4. Unscrew the Speaker Module Pan Head Screws on the bottom edge of the TV,
that attach the Speaker Module to the TV (Figure 2)
WARNING: Always replace Speaker Module Mounting Screws. Failure to
do so will allow water to seep inside your TV. This can cause serious injury
and can damage your TV.
4. Gently remove the Speaker Module away from the TV. Note that the Speaker
Module Cable Connector is connected to the TV Cable Connector (Figure 3).
5. Disconnect the Speaker Module Cable Connector from the TV Cable
Connector (Figure 3-A).
6. Push the TV Cable Connector back into the TV (Figure 4).
7. Push the Plastic Plug (found in Operators Manual Plastic Envelope)
into the hole (Figure 5).
WARNING: Make sure the plastic plug is put in the hole securely. Failure
to do so will allow water to seep inside your TV. This can cause serious
injury and can damage your TV (Figure 6.)
Pan Head Screws
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Speaker Module
Unscrew the two Speaker
Module Pan Head Screws
TV Installation - Detachable Speaker Module Installation
Figure 3-A