Filter
Top Products
_
11
_
ENGLISH
1. Press the POWER switch ON.
2. Set the REV MODE switch to the
required tape travel mode.
3. Load a pre-recorded cassette with its
open edge facing down and side A
facing toward you.
4. Select ON/OFF of the DOLBY NR system.
5. Press the
” or ∏ button to start
playback.
6. Adjust the volume with the amplifier's
volume control.
O To stop playback, press the STOP
button.
Playback
The tape counter counts up when the tape
is moving forward and down when the tape
is being rewound. The display can be
cleared by pressing the COUNTER CLEAR
button, which resets the counter index to
"0000".
Tape Counter
Cassette Deck Operation
COUNTER CLEAR
REC REVEL
STOP
RECORD
SOURCE
REV MODE
POWER
EJECT
DOLBY NR
1. Press the POWER switch ON.
2. Set the REV MODE switch.
O If you want to make a bi-directional
recording, set the REV MODE switch to
the
π or ø position.
O When starting to record with ”
ú
, one
side recording is performed.
O Set to the “ position if recording is to
be made on a single side of the tape.
3. Load a recordable cassette.
O Check that the safety tabs on the spine
of the cassette are in place. If they
have been broken off, block the holes
with adhesive tape.
4. Select the SOURCE switch.
O When selecting "CD", the built-in CD
player's output is selected as a source.
O When selecting "LINE", the external
signal from "LINE IN" is selected as a
source.
5. Select ON/OFF of the DOLBY NR system.
6. Press the RECORD button and the deck
enters the Record-Pause mode (REC
and
ƒ indicators light).
7. Adjust the recording level with the REC
LEVEL control so that the loudest sound
to be recorded just makes the meters
briefly reach around the "0 dB" point (for
Normal or Chrome tapes) or the "+3 dB"
point (for Metal tapes).
Recording
Metal
Normal or chrome
Loading a Cassette Tape
1. Use your finger or a pencil to turn the
cassette's hub and take up any slack
tape.
Note: Avoid touching the tape.
Fingerprints attract dust and dirt.
2. Press the eject button (
∫)* to open
the cassette compartment door.
3. Load the cassette tape with its open
edge facing down.
4. Gently close the compartment door.
*Notes:
OThe cassette holder cannot be
opened during recording or playback.
OIf the power has been switched off
during play or recording, ejecting the
cassette may be impossible. In such
a case, switch the power on and
press the eject button again.
8. Press the ƒPAUSE button again to start
recording.
O To stop recording temporarily, press the
ƒPAUSE button. To restart the tape,
press the
ƒPAUSE button or ”∏play
button. During the Record-Pause mode,
if the button whose
”, ∏ indicator is
lit is pressed, recording will start;
however, if the button whose
”, ∏
indicator is not lit is pressed, only the
tape direction will change; to restart the
tape, press the button again.
O To stop recording, press the STOP
button.
Anything previously recorded on the tape
will automatically be erased when you
make a new recording on it. It can also be
erased by "recording" on it with the REC
LEVEL control set to "0".
CAUTION
Recording pre-recorded tapes, records, or
other published or broadcast material may
infringe copyright laws. Check before
recording.
Erasing