Filter
Top Products
Power Requirements
3-10
Details
3.3.4 Power Requirements
The TPA311 Audio Power Amplifier Evaluation Module can operate from any
voltage between approximately 2 V and 5.5 V, however, the TPA311 amplifier
IC on the module is characterized for operation at 3.3 V and 5 V. For best
performance (highest output power with lowest distortion), the module should
be operated at approximately 5 V unless there is a specific reason for
operating it from a lower voltage.
The TI Plug-N-Play Audio Amplifier Evaluation Platform with a voltage
regulator EVM installed on it can provide a regulated V
DD
supply from a wide
variety of unregulated V
CC
voltage inputs between approximately 5.5 V and
12 V, including an on-board 9-V battery. Or, an external regulated power
source can be used to supply V
DD
voltage to the platform and the TPA311
evaluation modules installed on it.
The platform is equipped with overvoltage and reverse-polarity supply voltage
input protection in the form of fused crowbar circuits.
V
DD
voltage applied to platform screw terminals J6
MUST NOT
exceed
the absolute maximum rating for the TPA311 amplifier IC installed on the
evaluation module (6 V) or damage to the IC may result. In no case should
V
DD
voltage of the incorrect polarity or in excess of 6.1 V be applied to
screw terminals J6 of the platform, or the power protection circuit on the
V
DD
line will trip.
V
CC
voltage applied to the platform
MUST NOT
exceed the maximum
voltage input specified for the voltage regulator module installed in socket
U6 (12 V for the SLVP097), or damage to the voltage regulator module
may result. In no case should V
CC
voltage applied to the platform exceed
15 V, or the overvoltage protection circuit on the V
CC
bus will trip.