Filter
Top Products
www.velodyne.com
8 - WiConnect User’s Manual
Connect Subwoofer
1. Use the included power cord to connect the subwoofer to a power outlet.
2. Turn the POWER switch to the ON position. The ACTIVE light should be yellow.
NOTE: After 12 minutes without receiving a signal, the ACTIVE light turns red to indicate STAND BY mode. The
subwoofer will automatically go from STAND BY mode to ACTIVE when it detects an audio signal.
3. Turn the VOLUME knob to MIN to prevent blasting music when you rst use the subwoofer. You can
increase the VOLUME to the correct level later.
4. You’re done. No more wires to connect!
5. Go to the Select Wireless Broadcast Channel instructions next.
Select Wireless Broadcast Channel
The wireless transmitter can broadcast your audio signals on one of four selectable channels. Multiple channels
are made available in case other devices in your home are using some of the channels for communication.
To select the broadcast channel:
1. Review the Wireless Broadcast Considerations below.
2. Use the CHANNEL switch on the back of the wireless transmitter to select “1”, “2”, “3”, or “4” as the
broadcast channel.
3. Use the CHANNEL switch on the back of the subwoofer to select the same broadcast channel as you
selected on the wireless transmitter.
4. Go to the Adjust Subwoofer Controls for Listening Preferences instructions next.
Wireless Broadcast Considerations
All wireless devices like the WiC-10 may be susceptible to radio frequency (RF) interference from other devices.
Other RF devices include WiFi Internet access, computer equipment and routers; WiFi solar panel monitoring
systems; video game consoles, cordless telephones, blue tooth devices, baby monitors and microwave ovens.
In particular, any devices operating in the 2.4 GHz band may cause intermittent wireless connections between
the wireless transmitter and subwoofer.
To prevent wireless broadcast interference problems, keep wireless devices at least 2’ apart. Any interference
eects from a microwave oven will cease once the oven stops operating and may be resolved on a long-term
basis by increasing the physical distance between the subwoofer and the microwave oven.
If the WiC-10 sound is intermittent, check that another wireless device isn’t within 2’ of either the wireless
transmitter or the subwoofer.