Filter
Top Products
9
2.3.2. Inserting the batteries in the remote
control
The remote control is powered by two 1.5V AAA
batteries.
To install or replace batteries:
1. Press and then slide the cover to open it.
2. Align the batteries according to the (+) and (–)
indications inside the battery compartment.
3. Replace the cover.
Caution:
The incorrect use of batteries can result in leaks or
bursting. Be sure to follow these instructions:
• Place “AAA” batteries matching the (+) and (–)
signs on each battery to the (+) and (–) signs of
the battery compartment.
• Do not mix battery types.
• Do not combine new batteries with used ones.
It causes shorter life or leakage of batteries.
• Remove the dead batteries immediately to
prevent them from liquid leaking in the battery
compartment. Don’t touch exposed battery acid,
as it can damage your skin.
NOTE: If you do not intend to use the remote
control for a long period, remove the
batteries.
2.3.3. Handling the remote control
• Do not subject to strong shock.
• Do not allow water or other liquid to splash the
remote control. If the remote control gets wet,
wipe it dry immediately.
• Avoid exposure to heat and steam.
• Other than to install the batteries, do not open
the remote control.
2.3.4. Operating range of the remote control
Point the top of the remote control toward the
display’s remote control sensor when pressing a
button.
Use the remote control within a distance of less
than 10m/33ft from the display’s sensor, and
a horizontal and vertical angle of less than 30
degrees.
NOTE: The remote control may not function
properly when the remote control sensor on
the display is under direct sunlight or strong
illumination, or when there is an obstacle in
the path of signal transmission.
30 30
POWER
SMART
VIDEO
SOURCE
PIP
INPUTON/OFF CHANGE
BRIGHTNESSCONTRAST
DISPLAY
AUTO
ADJUST
VOL UP
VOL DOWN
EXIT
MENU
SET
AUDIO
SOURCE
OPTION