Filter
Top Products
65
Remote
Control
8 s B 42 000: Disable
001: Enable
002: Pass through
Disable: RCU has
no effect on HDTV.
Enabled: RCU controls
the HDTV. This is the
power up default on the
HDTV.
Pass through: RCU
has no effect on HDTV
and all RCU command
codes are transmitted to
FC via the RS232 port.
See page 26 for more
details
Setup wizard 8 s C 43 000: Disable
001: Enable
(for TV)
Disable: to skip the
initial setup wizard
Tiling-Mode 8 s P 50 000: OFF
001: ON
(for DS)
Tiling-Com-
pensation
8 s Q 51 000: OFF
001: ON
(for DS)
Bezel width
compensation
Tiling-H by V
Monitors
8 s R 52 01x~09x: H
0x1~0x9: V
(for DS)
1. 2
nd
digital for
H monitors
2. 3
rd
digital for
V monitors
Tiling-
Position
8 s S 53 001~025 (for DS)
Copy the screen of
Position# to identified
display
Restore
default
8 s ~ 7E 000 Rests HDTV to factory
setting
NOTE:
1. Behavior at lock modes
Lock Mode Behavior
Button Lock 1. Lock all buttons on the front panel and RCU, except for
“Power”.
2. All the SET functions should be workable via RS32, even the
ones with according hot key in RCU like Mute,…etc.
MENU Lock 1. Lock “MENU’ key on the front panel and RCU.
2. The Factory and Hospitality modes should not be blocked
for the model using MENU-combined key to enter these two
modes. Alternative approach will be indicated separately if
any limitation by model.