Filter
Top Products
Vincent
4140
Vincent
SEARCH FOR ERRORS
Symptom Possible Cause Countermeasure
USB storage
medium is not
accepted - the LED
“DISK” does not
light up.
The file system or the device class of the
USB device does not meet requirements.
Pull out the USB connector and put it back in.
If it still does not work, the USB device
cannot be used with the SA-96.
The music files
are not
accepted - the LED
“MP3” does not
light up.
There are no valid MP3 files on the
connected data medium/player.
Copy suitable MP3 files on to the USB
device before inserting it in the SA-96.
The remote control
cannot perform any
functions
No batteries inserted in the remote control,
batteries are not inserted correctly or are
depleted.
The line-of-sight between the remote control
and the unit is obstructed, the range was
exceeded or the hand unit was operated from
a position too far to one side.
The unit is not switched on.
Check and replace the batteries if necessary.
Try to point the remote control at the front of
the unit only when the sight-line is clear,
within a 7-metre distance and, if possible,
facing the unit.
Switch on the unit.
Humming low
frequency noise is
audible, even as no
audio source is
playing back
See section “Net frequency noise” in the chapter “Tips”.
Frequency response: 20 Hz - 20 kHz (±0.5dB)
Total Harmonic Distortion: < 0.1% (1 kHz, 0.1 W)
Signal to Noise Ratio: > 90 dB
Gain: 11.6 dB
Input sensitivity: 380 mV
Input Impedance: 47 kΩ
Channel separation: > 80 dB
Nominal output voltage preamplifier output: 2 V
Nominal output voltage headphone output: 1 W at 32Ω
Nominal output power preamplifier output: 250 mW at 300Ω
AC power connection type: 220V-240V / 50 Hz
Power Consumption: 20 W
Inputs: 3x RCA high level input stereo,
1x USB
Outputs: 2x RCA stereo (PRE OUT),
1x RCA stereo (REC OUT),
1x headphone (6.3 mm jack socket),
2x POWER CONTROL (3.5 mm jack socket)
Dimensions (WxHxD): 93x234x220 mm
Weight: 3 kg
Colour: silver / black
TECHNICAL SPECIFICATIONS