Filter
Top Products
3
MM-3003
Stop Collar
2
1
3
4
Pin
FIGURE 4
STEP 3. Attach the MM-3084 (pipe that antenna
mounts on) to your truck/RV. If using the MM-3002
clamp brackets, proceed to step 9. If using the MM-
3003 clamp brackets, proceed to step 4.
MM-3003 Assembly
STEP 4. Disassemble pipe per number sequence
shown in Figure 4 so that you can slide both MM-3003
brackets onto the pipe.
STEP 5. Reassemble pipe after sliding both clamp
brackets onto pipe; make sure the stop collar snaps
firmly onto the pin.
STEP 6. Determine where you want to mount the
pipe. It is recommended that you try to bolt into
something solid on your truck/RV and someplace close
to a window so you can listen/watch your TV when
tuning the system. Make sure pipe is vertical (straight
up and down), this will make finding the satellite(s)
easier. Also make sure antenna will clear top of
truck/RV (if possible). NOTE: A second set of
clamp brackets and pipe is recommended for other
side of truck. Winegard Company cannot recommend
specific mounting locations because of the many truck/
RV styles.
Elevation
Clamp
Use (2) 5/16" x 1-1/2"
bolts supplied per
clamp
FIGURE 5
STEP 8. Tighten clamp bracket bolts to prevent pipe
from moving, See Figure 5. You are now ready to aim
the antenna; proceed to Operation, page 5.
Make sure pipe
is vertical
Try to maintain as
much separation
between the
clamp brackets
as possible.
See Figure 7,
page 4.
STEP 7. Use (4) 5/16" x 1-1/2" bolts supplied to secure
pipe clamp brackets to side of truck/RV. See Figure 5.
Try to maintain as much separation between the
clamp brackets as possible. See Figure 7. It is
recommended that you attach the top clamp with one
bolt, then check vertical alignment before attaching
bottom clamp and finishing top.
Tighten bolt to prevent
pipe from moving
Rev. 5/99