Filter
Top Products
4
MM-3002 Assembly
STEP 9. Slip the small plastic shims over the handrail/
ladder and the large plastic shims over the MM-3084
pipe. See Figure 6.
NOTE: If MM-3002 comes with eight (8) rubber
shims instead of the 4 plastic clamp grips. Insert
rubber shims between clamp brackets and MM-
3001 pipie and handrail/ladder. See Figure 6.
STEP 10. Attach clamp brackets to pipe and handrail/
ladder using carriage bolts, nuts and washers supplied
with MM-3002. Do not crush handrail/ladder. Try to
maintain as much separation between the clamp brackets
as possible. See Figure 7. Make sure pipe is vertical
(straight up and down). Your now ready to aim the
antenna; proceed to Operation, page 5.
Try to maintain
maximum separation
between clamps
FIGURE 7
Handrail/Ladder
(4) 5/16"
Washers
(4) 5/16-18
Hex Nuts
MM-3084 Pipe with
MM-3003 Clamp Brackets
MM-3084 Pipe with
MM-3002 Clamp Brackets
(4) 5/16-18 x 1-3/4"
Carriage Bolts
Slip plastic clamp
grips over pipes as
shown (if using using
rubber shims, place
between clamp
brackets and pipes).
FIGURE 6
Rev. 5/99