Yamaha CD-S700 Car Stereo System User Manual


 
TROUBLESHOOTING
20 En
Audio Section
Frequency response......................................2 Hz - 20 kHz, ± 0.5 dB
Harmonic distortion + noise (1 kHz).........................0.002 % or less
S/N ratio....................................................................110 dB or more
Dynamic ...................................................................100 dB or more
Output voltage (1 kHz, 0 dB)...........................................2.0 ± 0.3 V
Laser Diode Properties
Material.................................................................................GaAlAs
Wavelength ............................................................................790 nm
Laser Output..............................................................max. 1.23 μW*
* This output is the value measured at a distance of about 200 mm
from the objective lens surface on the Optical Pick-up Block.
General
Power requirements
U.S.A. and Canada models...............................AC 120 V, 60 Hz
Australia model ................................................AC 240 V, 50 Hz
Europe and U.K. models .......................... AC 220-240 V, 50 Hz
Asia and General models.......AC 110-120/220-240 V, 50/60 Hz
Korea model.....................................................AC 220 V, 60 Hz
China model......................................................AC 220 V, 50 Hz
Power consumption...................................................................16 W
Dimensions (W × H × D)...................................435 × 96 × 300 mm
Weight ......................................................................................6.2 kg
Please note that all specifications are subject to change
without notice.
The remote control
does not work or
function properly.
Wrong distance or angle. The remote control functions within a
maximum range of 6 m (20 ft) and no more than
30 degrees off-axis from the front panel.
6
Direct sunlight or lighting (from an inverter type
of fluorescent lamp, etc.) is striking the remote
control sensor of this unit.
Reposition this unit.
The batteries are weak. Replace all batteries. 6
SPECIFICATIONS
Problems Possible Causes Solutions
Refer to
page