Filter
Top Products
27 En
Connections
PREPARATION
English
■ AC OUTLET (SWITCHED)
Use this outlet to supply power to any connected
components. Connect the power cable of your other
components to this outlet. Power to this outlet is supplied
when this unit is turned on. However, power to this outlet
is cut off when this unit is turned off or when
C
STANDBY/ON on the front panel is pressed. For
information on the maximum power or the total power
consumption of the components that can be connected to
this outlet, see “Specifications” on page 109.
The power to AC OUTLET of this unit is not cut off while this
unit is charging connected iPod even when this unit is in the
standby mode. When this unit completes charging or the iPod is
disconnected, the power is cut off automatically when this unit is
in the standby mode.
1 Make sure this unit turned off.
See page 28 for details.
2 Press and hold
D
TONE CONTROL and
then press
C
STANDBY/ON to turn on this
unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3 Rotate the
E
PROGRAM selector to select
“SP IMP.”.
“SP IMP.” and the current speaker impedance setting
(“8Ω MIN”) appear in the front panel display.
4 Press
D
TONE CONTROL repeatedly to
select “6ΩMIN”.
5 Press
C
STANDBY/ON to save the new
setting and turn off this unit.
The setting you made is reflected next time you turn on this
unit.
Connecting the power cable
Note
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby mode.
However, the stored data will be lost in case the power
cable is disconnected from the AC wall outlet or if the
power supply is cut off for more than one week.
AC OUTLET
SWITCHED
100W MAX.
0.4A MAX.
DVRMONITOR OUT
C
To the AC wall outlet
Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to
“6ΩMIN” as follows BEFORE using this unit. 4 ohm
speakers can be also used as the front speakers.
Note
TONE CONTROL
STANDBY
/ON
While holding
down
01EN_00_DSP-AX763_B.book Page 27 Thursday, January 31, 2008 9:41 AM