55
Topside Controller Instructions cont...
Preset Filter Cycles/ Optional Filter Cycles
Preset Filter Cycles
The rst lter cycle is automatically activated at 8:00am and oper-
ates the low speed of pump one* (or the circulation pump if spa is
equiped) until 10:00am.
The second lter cycle is automatically activated at 8:00pm and
operated the low speed of pump 1 until 10:00pm.
the low speed of pump one and the ozone generator will run during
ltration. At the start of each lter cycle, the therapy pumps will run
on high speed for the rst ve minutes.
(*) - Spa equipped with circulation pump is preset to run 24 hours
from the factory, please see the next section to adjust the duration
of the circulation pump cycle.
Optional Filter Cycles (Summer Mode)
During the warm summer months it is advisable to lower the
set temp to 85 F or less, to reduce the lter cycle circulation,
and to set the spa in “economy mode”.
While you are not required to set the lter cycles, if you want to
change them press “Time”, “Mode”, “Mode” within three seconds.
“SET START FILTER 1” (AM cycle) will appear on the display.
Press “Warm” or “Cool” to reset the lter start time.
Press “Mode” to see “SET STOP FILTER 1” and adjust the time
with “Warm” or “Cool” as done above. Press “Mode” to see “SET
START FILTER 2” (PM cycle) and proceed as above.
Pressing “Mode” will enter the new lter cycle times into the system
and display the current water temperature.
