Chapter 4. Local Console Operation
39
Hotkey Beeper Control
The Beeper (see ACTIVATE BEEPER, page 28) can be Hotkey toggled On and
Off. When the beeper is set to On, the KH1508i / KH1516i beeps when it
switches ports. To toggle the Beeper, key in the following Hotkey
combination:
1. Invoke Hotkey Mode (see page 34).
2. Press [B]
After you press B, the Beeper toggles On or Off. The Command Line displays
Beeper On or Beeper Off for one second; then the message disappears and you
automatically exit Hotkey Mode.
Hotkey Summary Table
The following table summarizes Hotkey operations on the KH1508i /
KH1516i:
[Num Lock] + [-] [Port ID] [Enter] Switches access to the computer that
corresponds to that Port ID.
[T] [n] [Enter] Sets the Auto Scan interval to n seconds -
where n is a number from 0–255.
[A] Invokes Auto Scan Mode.
When Auto Scan Mode is in effect, [P] pauses
Auto Scanning.
When Auto Scanning is paused, pressing any
key resumes Auto Scanning.
[
←]
Invokes Skip Mode and skips from the current
port to the first accessible port previous to it.
[
→]
Invokes Skip Mode and skips from the current
port to the next accessible port.
[
↑]
Invokes Skip Mode and skips from the current
port to the last accessible port of the previous
Station.
[
↓]
Invokes Skip Mode and skips from the current
port to the first accessible port of the next
Station.
[B] Toggles the Beeper On or Off.
kh15816i.book Page 39 Wednesday, December 26, 2007 11:12 AM
