Chapter 1. Introduction
9
Keyboard Module
(Continues on next page.)
No. Component Description
1 Port LEDs
An On Line LED lights to indicate that the device attached
to its corresponding port is up and running.
A Selected LED lights to indicate that the computer
attached to its corresponding port has the KVM focus.
2 Keyboard Standard 105-key keyboard
2 Touchpad Standard mouse touchpad
4 Reset Switch
Pressing and holding this switch in while powering on the
unit causes the KL9108 / KL9116 to revert to the original
factory installed firmware version – allowing you to recover
from a failed firmware upgrade.
Pressing and holding this switch in for more than three
seconds performs a system reset.
Note: The switch is recessed and must be pushed with a thin
object - such as the end of a paper clip or a ballpoint pen.
5 Port Selection
Switches
The left button (DOWN), shifts the KVM focus down
through the ports (Port 7
→ Port 6, etc.). After Port 1, it
cycles back to the last port.
The right button (UP), shifts the KVM focus up through the
ports. After the last port, it cycles to Port 1.
2
3
1
7
9
8
4
6
5
