Introduction
2-1
2
4600 Series IP Telephone Installation
2
Program
Introduction
2
The new 4600 Series IP Telephone product line uses Internet Protocol (IP) technology with
Ethernet interfaces. The IP telephones supplement the existing DEFINITY IP Solutions platform.
The 4600 Series IP Telephones support DHCP and TFTP over IPv4/UDP which enhance the
administration and servicing of the phones. These phones use DHCP to obtain dynamic IP
addresses and TFTP to download new versions of software for the phones.
The 4600 Series IP Telephones provide the ability to have one IP connection on the desktop for
both a telephone set and a PC using the telephone’s built-in hub.
For information on Voice over IP, see the 4600 Series IP Telephone LAN Administrator’s Guide.
In compliance with Australian law, the following information is provided:
This equipment shall be installed and maintained by trained service personnel. All the input/output
ports are classified as Safety Extra Low Voltage (SELV, in the meaning of IEC 60950). To maintain
safety compliance when connecting the equipment electrically to other equipment, the
interconnecting circuits shall be selected to provide continued conformance of clause 2.3 for SELV
circuits (generally, double/reinforced insulation to 240Vac rms to any primary/mains circuitry and
120Vac rms to any Telecommunication network circuitry). To ensure the above conditions are
adhered to, only interconnect the equipment with the already approved/certified equipment.
IP Telephone Models
2
There are three telephone set models defined in the 4600 Series IP Telephone family:
■
4606 IP Telephone
■
4612 IP Telephone
■
4624 IP Telephone
This document describes the installation of these phones. For details about using the features
provided by the phones, refer to the documentation for each phone.
