A SERVICE OF

logo

SL236 Motor Replacement Service Manual
4
10. Attach wire or something of equivalent strength to the joist
mounting tabs on the SL236.
11. Connect these wires to the front of hinge assembly. (See
Figure 4)
IMPORTANT ! : Wires should be connected in minimum
of two places to prevent the hinge assembly from
dropping when the motor is removed.
Figure 4
12. Remove motor cover and wiring cover by removing six
Phillips head machine screws. (See Figure 5)
NOTE: The wiring cover will only be present on newer units.
Older units will not have this cover.
Figure 5
13. Remove four set screws from each of the two motor
couplers. (See Figure 6)
Figure 6
Joist Mounting Tabs
9
x 6
Motor Cover
Wiring cover
x 8
10