A SERVICE OF

logo

SL236 Motor Replacement Service Manual
6
6. Replace the motor cover and wiring cover (if present) and
fasten with six 8-32 x 5/16" Phillips head screws (H) . (See
Figure 10)
Figure 10
7. Replace plate removed in Step 5 of Removing Motor
section and fasten with six 10-24 x 3/16" Phillips head
screws (L). (See Figure 11)
NOTE: Install middle screw on each side first and set plate on
top of two middle screws before adding additional four
screws.
Figure 11
8. Remove cable or wires attached to mounting tabs in Step
10 of Removing Motor section.
9. Restore power to SL236.
10. Verify that SL236 is operating properly when moving up and
down.
11. Remove power from SL236.
(H) x 6
6
Motor cover
7
(L) x 6
Install middle
screw first