Installing the Linux operating systems with out of kernel drivers onto a boot device using FCoE Adapters
167
Configuring a Boot Device on an EMC Storage Array
The following message displays:
Make sure that CD number 1 is in your drive.
8. Put SLES10 CD 1 in the drive and press OK.
9. Follow the on-screen instructions to complete the installation.
SLES 11 OS SAN-boot installation with QLogic FCoE adapters
To install SLES 11 SAN-boot with QLogic FCoE adapters:
1. . Obtain the appropriate “DD” driver kit for the QLogic FCoE
adapter from the EMC-supported section of the QLogic website,
and copy it to the appropriate media (floppy disk or CD).
2. Insert the SLES 11 DVD #1 in CD drive and boot the system.
3. On the main installation screen, press F5.
4. The system prompts you to select Yes, No, or File.
Select Yes.
5. Select the installation option, then press ENTER
In response to the following prompt:
Please choose the driver update medium.
a. Make sure the dd-kit is inserted in proper drive (i.e., CD-ROM
or floppy).
b. Select appropriate drive, then press ENTER.
This loads the driver update to the system.
6. If the driver update was successful, the following message
displays:
Driver Update OK.
Press ENTER.
7. If the system prompts you to update another driver, click BACK,
then press ENTER.on an EMC Storage Array
The following message displays:
Make sure that CD number 1 is in your drive.
8. Put SLES 11 DVD 1 in the drive and press OK.
9. Follow the on-screen instructions to complete the installation.
