Operation
SettingSetting
Setting
UpUp
Up
thethe
the
EquipmentEquipment
Equipment
1. Disconnect the abrasive hose at the cam and
groove with the abrasive ball valve closed.
NOTE:NOTE:
NOTE:
If the pot contains water and abrasive
(especially under pressure), releasing the cam
and groove with the ball valve open will cause an
unintentional release of abrasive.
2. Flush water through the pot and out the
disconnected abrasive ball valve before lling the
pot with water and abrasive.
3. Reconnect the abrasive hose.
4. Disconnect the pump inlet hose and ush the
water tank to remove any remaining debris.
Reconnect the pump inlet hose.
5. Fill the water tank only with fresh water, then
open the inlet ball valve.
6. Close the rinse, dump, and abrasive ball valves.
7.
334667B
11
