HT Omega DP3409 Manual

A SERVICE OF

next previous

18

4 CONFIGURATION MODE

4.1 Introduction

The Configuration Mode comprises two levels (3 and 4) as shown in Fig. 4.2.

Configuration Level 3 is divided into four frames. For most simple applications, it is

only necessary to set up the parameters in the first frame.

Note.

When in the configuration level:

• All the LED indicators flash.

• All relays and logic outputs are turned off.

• The analog output reverts to 0% (4mA) output level.

4.2 Accessing the Configuration Mode – Fig. 4.1

To access the Configuration Mode, set the security switch to the 'Configure'

position (Levels 1 and 2 cannot be accessed from this setting). When the

configuration parameters are programmed, reset the security switch to the 'Normal'

position and the operating page is displayed automatically .

Fig. 4.1 Accessing the Configuration Mode

Normal

Configure