STEP 22:
FIGURE 22
22
STEP 23:
FIGURE 23
• Insert one 5-1/2” PIVOT SHAFT (41) into the MULTI PRESS FRAME (8) and one 5-1/2” PIVOT SHAFT (41) into the BACK PAD
SUPPORT (7) as shown in FIGURE 22.
41
7
3
8
41
• SECURELY assemble two MULTI PRESS PLATES (18) to the BACK PAD SUPPORT (7) and to the MULTI PRESS FRAME (8)
using four BLACK RH CAPS (68), two 3/8 X 164mm BOLTS (61), four 3/8” SAE WASHERS (66), four 3/8” RH WASHERS (67) and two
3/8” LOW HEIGHT LOCK NUTS (65) as shown in FIGURE 23.
• SECURELY assemble the SEAT PAD SUPPORT (3) to the MULTI PRESS SEAT ADJUST (6) using two BLACK RH CAPS (68),
one 3/8 X 106mm BOLT (60), two 3/8” SAE WASHERS (66), two 3/8” RH WASHERS (67) and one 3/8” LOW HEIGHT LOCK NUT (65)
as shown in FIGURE 23. (NOTE: TIghten connections enough to remove slop, yet allow part to rotate freely.)
60 3/8 X 106mm
3/8 X 164mm 61
7
8
3
6
66
67
65
18
68 BLACK
68 BLACK
• SECURELY assemble the BACK PAD SUPPORT (7) to the MULTI PRESS SEAT ADJUST (6) using two BLACK RH CAPS (68),
one 3/8 X 106mm BOLT (60), two 3/8” SAE WASHERS (66), two 3/8” RH WASHERS (67) and one 3/8” LOW HEIGHT LOCK NUT (65)
as shown in FIGURE 23. (NOTE: TIghten connections enough to remove slop, yet allow part to rotate freely.)
