35
STEP 40:
FIGURE 40
• SECURELY assemble theLEG PRESS SEAT PAD (91) to the LEG PRESS FRAME (85) using two RH CAPS (109), two 3/8 X 73mm BOLTS
(103),two 3/8” SAE WASHERS (106) and two 3/8” RH WASHERS (107) as shown in FIGURE 40.
103 3/8 X 73mm
109
91
85
106
107
STEP 41:
FIGURE 41
• Route the LEG PRESS CABLE (93) through the MAIN PIVOT ARM (87) and assemble one 4-1/2” PULLEY (94) to the MAIN
PIVOT ARM (87) using two RH CAPS (109), one 3/8 X 67mm BOLT (101), two 3/8 X 1/2” FLANGE SPACERS (96), two 3/8” SAE
WASHERS (106), two 3/8” RH WASHERS (107) and one 3/8” LOW HEIGHT LOCK NUT (105) as shown in FIGURE 41.
• Route the LEG PRESS CABLE (93) between the upper bracket and through the tube on the LEG PRESS FRAME (85) and assemble
one 4-1/2” PULLEY (94) to the FRAME (85) using two RH CAPS (109), one 3/8 X 50mm BOLT (100), two 3/8” SAE WASHERS (106),
two 3/8” RH WASHERS (107) and one 3/8” LOW HEIGHT LOCK NUT (105) as shown in FIGURE 41.
• Route the LEG PRESS CABLE (93) between the lower BRACKETS on the LEG PRESS FRAME (85) and assemble one 4-1/2”
PULLEY (94) to the FRAME (85) using two RH CAPS (109), one 3/8 X 50mm BOLT (100), two 3/8” SAE WASHERS (106), two 3/8” RH
WASHERS (107) and one 3/8” LOW HEIGHT LOCK NUT (105) as shown in FIGURE 41.
100 3/8 X 50mm
109
106
107
96
87
85
105
94
101 3/8 X 67mm
93
