Quick Start 17
E-EQ-MX5CEOGWW-F-ARC MX5X User’s Guide
Install Handstrap (Optional)
Note: Either the trigger handle is attached to the MX5X or the handstrap is attached, not both.
LXE recommends that, in the absence of a trigger handle, the handstrap be used at all
times.
An elastic hand strap is available for the MX5X. Once installed, the hand strap provides a means
for the user to secure the computer to their hand. It is adjustable to fit practically any size hand
with or without workgloves and is easily moved aside to allow installation or removal of the main
battery pack.
Figure 14 MX5X With Handstrap Installed
Installation
1. If a handle is installed, remove it at this time. See section Install Pistol Grip Handle.
2. Slip the strap through the upper bracket prior to securing the upper bracket to the
unit.
3. When slipping the strap through the bracket make sure the closed loop fastener
surface is up.
4. After slipping the strap through the bracket, fold the strap over so that the two closed
loop fastener surfaces mate evenly.
5. Prior to securing the upper bracket to the unit, slide the bottom assembly into the slots
at the bottom of the MX5X. Make sure that both ends of the bottom assembly are
securely installed.
6. After securing the bottom of the strap to the MX5X, loosen the closed loop fastener
strap and then secure the upper bracket to the unit with a screw(s).
Removal
1. Separate the closed loop fastener tabs and loosen the strap through the upper bracket.
2. Using a Phillips screwdriver, remove the upper bracket screw(s).
3. Pull the bottom assembly from the slots in the bottom back of the MX5X.
