5. BASE SPECIFICATIONS PARAMETERS
II - 56
# Items Details Setting range (unit)
1223 aux07
(bit0)
Not used.
aux07
(bit1)
Deceleration
check method 2
Select the deceleration check method in G1+G9.
0: Command deceleration check in G1+G9
1: In-position check in G1+G9
The deceleration check is not performed except
G1+G9.
When "#1306 InpsTyp deceleration check
specification type" is set to 1 (Deceleration check
specification type 2), this parameter will be invalid.
0/1
aux07
(bit2)
Synchronous
tap R-point
in-position
check
0: Disable the synchronous tap I-point → R-point
in-position check.
1: Enable the synchronous tap I-point → R-point
in-position check.
Note: This parameter is valid only when 1 (in-position
check is valid) is set in bit 3 of #1223 aux07
(synchronous tap in-position check
improvement).
0/1
aux07
(bit3)
Synchronous
tap in-position
check
improvement
Specify whether to enable the synchronous tap
in-position check improvement function.
0: Disable
1: Enable
Related parameters:
#1223
bit 2 Synchronous tap R-point in-position check
bit 4 Synchronous tap hole bottom in-position check
bit 5 Synchronous tap R-point in-position check 2
0/1
