20 Plasma TV
Use of the Remote Control with Other
Use of the Remote Control with Other
A/V Products
A/V Products
(Figures 1-3 this page, figures 4-5 following page)
1. Move the slide switch at the top of the remote to
the product you want to control.
2. Press and hold the POWER button on the remote
control.
3. Enter the first three digit code listed for your equip-
ment, and then release the POWER button on the
remote control.
4. Point the remote control to the equipment and
press the POWER button.
Note: If the equipment responds, the remote control
is properly programmed to operate the equipment.
If the equipment does not respond, repeat steps 2-
4 with the next three digit code listed in step 3 for
your equipment.
Programming the Remote Control to Use with
Programming the Remote Control to Use with
Other Brands of
Other Brands of
Audio and V
Audio and V
ideo Products:
ideo Products:
listing.
1.
3.
2.
listing.
1.
2.
3.
IMPORTANT
When set to TV, the PLAY, STOP, REW/REV, and FF/FWD
buttons will operate the VCR after the VCR codes have
been properly programmed into the remote control.
Figure 1. Programming the remote to control your cable box.
Figure 2. Programming the remote to control your satellite
receiver.
Figure 3. Programming the remote to control your VCR.
