listing.
1.
2.
3.
listing.
1.
3.
2.
After entering the correct codes in each position of the
remote control, use the slide switch to select which
product will respond when an operational button is
pressed. If you enter a code from the AUDIO chart while
the slide switch is set to TV, the volume and mute func-
tions change to match the A/V receiver. This is useful
when using an A/V receiver with the TV all the time. In
all other cases, only one of the below devices is allowed
for each slide switch position.
TV position:
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
VCR position:
VCR
DVD position:
DVD
LD Player
Audio position:
A/V receiver
Mitsubishi CD player
If you have a Mitsubishi A/V receiver, the audio position
may be used in conjunction with select Mitsubishi CD
players. Your audio position must be programmed to
either 010 or 011. Plug the CD player power cord into a
switched outlet on the back of your A/V receiver.
Pressing the POWER button turns On the A/V receiver,
along with the CD player. In the audio position, for some
CD players, the transport controls (FF, Play, Rew, etc.)
operate the CD player.
IMPORTANT
If the slide switch is set to TV when you enter an A/V
receiver code, VOLUME and MUTE will control the A/V
receiver rather than the TV. To return volume and mute
control to the TV, set the slide switch to TV, press and hold
POWER and enter 000.
IMPORTANT
Some manufacturers may change their products, or
they may use more than one remote control system.
If this is the case, your remote control may not be
able to operate your VCR, DVD, cable box, satellite
receiver, or A/V receiver.
Figure 4. Programming the remote to control your DVD or LDP.
Figure 5. Programming the remote to control your A/V receiver.
Use of the Remote Control with Other
Use of the Remote Control with Other
A/V Products
A/V Products
