807 BODYSMITH WORKOUT CENTER. ASSEMBLY INSTRUCTIONS
".~!~,:~ ::.’..’.;:., 5 ,. ..
’; ::::THE~+;8OT"’iBOD YSMITH WORK
FACE.TO ASSURE ITS PRI
Attach eight (8) PARAGLIDE STRIPS to the WOLFF SLEEVE (FOUR ON EACH END) as shown
(DETAIL A) using the follo~ving steps:
¯
Thoroughly clean all surfaces where the PARAGLIDE STRIPS are to be attached.
¯
Remove the PARAGLIDE STRIPS from the paper backing and firmly apply them to all shown
surfaces.
Insert one (1) U-PIN through the BUSHING of the WOLFF SLEEVE and one (1) U-PIN through
BUSHING of the BENCH FRAME as shown on drawing, and attach t~vo (2) PAL NUTS to the ends
the U-PINS.
SECURELY Assemble three (3) SPRING PIN ASSEMBLIES to the SPRING PIN HOUSINGS, two (2)
on the UPRIGHT TUBES. and one (1) on the WOLFF SLEEVE as shown in (DETAIL
(!!! IMPORTANT ~! TIGHTEN THE NUT OF THE SPRING PIN ASSEMBLY SECURELY)
Pull back the SPRING PIN on the WOLFF SLEEVE and slide it over the end of the BENCH FRAME as
shown on dra~ving. Engage the SPRING PIN into one of the adjustment holes. Secure the WOLFF
SLEEVE in place with one (11 THUMBSCREW.
Insert two (2) 2 IN. SQ. END CAPS into both ends of the BASE LEG as sho~vn o~ drawing.
Insert the BASE LEG into the fi’ont of the BENCH FRAME as shown on drawing. (MAKE SURE
THAT THE TAB ON THE BA.SE LEG IS UNDER THE BENCH FRAME)
Insert four ~4) 2 IN. SQ. END CAPS into the BASE TUBES of the UPRIGHT FRAME a:; sho~vn on
dl’aW in ~
