ParaBody 841101 Manual

next previous

FIGURE 9

3/8 X 3"~

1/2 X 3"(~~

STEP 9:

¯ Swing the GUIDE RODS (9) under the TOP BOOM (2) as shown on FIGURE

Assemble the TOP BOOM (2) over the GUIDE RODS (9) and SECURELY assemble the TOP BOOM (2) to the UPRIGHT

using two 1/2 X 3" BOLTS (28), two 1/2" WASHERS (29), and one 1/2" LOCK NUT (30). See FIGURE

SECURELY assemble the TOP BOOM (2) to the top of the POWER RACK using two 3/8 X 3" BOLTS (26), four 3/8" WASH-

ERS (31), and two 3/8" LOCK NUTS (32). See FIGURE

¯ Screw the threaded end of the LAT CABLE (15) approximately 3/4" into the end of the WEIGHT STACK SHAFT (13) and tighten

jamnut securely. See FIGURE 9.