867101 LAT OPTION ASSEMBLY INSTRUCTIONS
Insert one (1) 1-3/4 IN. SQ. END CAP into the from end of the LAT BASE, and two (2) 2-1/2 IN.
END CAPS into each end of the FOOT BRACE onthe LAT BASE as shown on drawing.
Attach two (2) 5-1/2 X 2-1/2 IN. NON SIGD STRIPS to the FOOT BRACE onthe LAT.BASE
shown on drawing.
SECURELY assemble one (1) 3/8 X 2-3/4 IN. BOLT, two (2) 3/8 IN. WASHERS, and one (1) 3/8
LOCK NUT to the second set of holes in the BASE of the UPRIGHT FRAME as shown on drawing.
Remove the 2 IN. SQ. END CAP from the BASE of the UPRIGHT FRAME and insert file LAT BASE
up to the BOLT as shown on drawing and secure it in place, using one (1) THUMBSCREW.
LOOSELY assemble the LAT UPRIGI~T to the BASE of the UPRIGHT FRAME as shown on
drawing using one (1) 3/8 X 3 IN. BOLT, two (2) 3/8 IN. WASHERS, and one 3/8 IN. LOCI( NUT
the OUTSI])E I]OLE, and one 3/8 X 3-1/4 IN. BOLT, three (3) 3/8 IN. WASHERS, and one 3/8 IN,
LOCI( NUT for the INSIDE ]]OLE. (DO NOT TIGHTEN TttE BOLT CONNECTIONS AT T]~IS
TIME)
Attach eight (8) CARRIAGE GUIDES to both ends of the CARRIAGE as shown in (DETAIL A) using
the following steps:
A.. Thoroughly clean all inside surfaces where the CARRIAGE GUIDES are to be attached.
Remove the paper bacldng from the CARRIAGE GUIDES and firrrdy apply fllem to all shown
surfaces (8 pIaces)
7. Attach one (1) 1-1/4 SQ. IN. RUBBER BUMPER to the center of the CARRL&GE STOP on the
CARRIAGE as shown on drawing.
4 04/15/97
