867101 LAT OPTION ASSEMBLY INSTRUCTIONS
16.
®
17.
18.
19.
20.
21.
22.
23.
24.
25.
Route file second CABLE (THE END WITHOUT WHITE BALL) under the LOW PULLEY a~tached
to the LOW PULLEY SUPPORT on the UPRIGHT FP~V~E. SECURELY fi~en the PULLEY
CONNECTION after the CABLE has been routed.
Route file CABLE up and around the SECOND PULLEY assembled to the CONNECTOR PLATES
from STEP 14 and down to the inside bolt connection of the LAT UPRIGHT.
SECURELY assemble the CABLE END to the 3/8 X 3-1/4 BOLT connection of the LAT UPRIGHT to
the UPRIGHT FRAME as shown on the CABLE ROUTING DIAGRAM. (MAKE SURE THAT
TI/ERE IS A WASHER ON BOTH SIDE OF THE CABLE END BEFORE TIGHTENING)
(TIGHTEN THE OTHER BOLT CONNECTION AT TEIS TIM_E)
See CABLE ROUTING DIAGRAM for help in completing STEP 16.
TIGHTEN ALL LOOSE BOLT CONNECTION FROM STEPS 5,10,11, AND 14.
Attach eight (8) PARAGLIDE STRIPS to the KNEE HOLD DOWN SUPPORT (FOUR ON EACH
END) as shown in (DETAIL C) using the following steps:
Thoroughly clean all surfaces where the PARAGLIDE STRIPS are to be attached.
®
Remove the PAIL&GLIDE STPOPS from the paper bacldng and fLrmly apply them to all shown
surfaces.
SECURELY Assemble one (1) SPRING PIN ASSEMBLY to the SPRING PIN BARREL of the KNEE
¯ HOLD DOWN SUPPORT, as shownin (DETAIL C). (!!!/MPORTANT !!! TIGHTEN THE
OF TH_E SPRING PIN ASSEMBLY SECURELY)
Attach two (2) CA2,RIAGE GUIDES to the KNEE HOLD DOWN SUPPORT as shown in (DETAIL
C).
SECURELY assemble file KNEE HOLD DOWN SUPPORT to the ARM CURL FRAME as shown
on drawing using one (1) 1/2 iX 3-1/2 IN. BOLT, two (2) 1/2 IN. WASHERS, and one (1) 1/2 IN.
NUT. (BEFORE TIGHTENING MAKE, SURE KNEE HOLD DOWN SUPPORT IS UP TIGHT
AGAINST THE BAR HOLDER OF THE ARM CURL FRAME)
Insert the ARM CURL FRAME into the ANGLED TUBE on the LAT BASE as shown on drawing,
and secure inplace using one (1) THUhdBSC1LEW.
Insert one (1) 1-3/4 IN. SQ. END CAP into file top end of the KNEE HOLD DOWN TUBE as shown
drawing.
Assemble two (2) ROLLER PADS to the KNEE HOLD DOWN TUBE as shown on drawing using one
(1) ROLLER PAD SHAFT and two (2) 3/4 IN. STARLOCK COLLARS.
Pull back on the SPRING PIN oll the KNEE HOLD DOWN SUPPORT and insert the KNEE HOLD
DOWN TUBE down to file desired hole setting and release the SPRING PIN. Secure in place with one
(I) THUM~ SCREW.
6
04/15/97
