COMSPHERE 6800 Series Network Management System
5-96 January 1997 6800-A2-GN22-30
NOTE
The total number of local terminals configured determines the
number of 6800 Series NMS cut-through sessions to an individual
ANALYSIS NMS. The following rules apply:
NUMBER OF LOCAL TERMINALS NUMBER OF CUT-THROUGHS ALLOWED
1 5
2—6 6—number of local terminals
On the ANALYSIS side, you will be asked as a part of the
syssetup
procedure to enter the number of permitted cut-throughs. It is
important that you enter the same number during that procedure as
is calculated in this step.
For example, assume you have two local terminals attached to your
ANALYSIS NMS. Enter 2 in this step and the
config6510
program will
determine that four cut-through sessions are permitted (6 minus 2 =
4). On the ANALYSIS NMS side, you should enter 4 when prompted
by the syssetup program for the number of cut-through sessions.
(For additional information, refer to the
ANALYSIS 6510 Automated
Network Management System Reference Manual)
.
5. The system prompts you to confirm the information entered in the previous steps.
Is the information correct [y or n, q to quit]?
TYPE: y (if the displayed information is correct)
PRESS: Enter
6. The database is updated and your selection is confirmed with the following message:
Please wait... “system name” added to system
where system name is the name entered in Step 2.
7. To exit the configuration process,
TYPE: 4
PRESS: Enter
8. To add more 6510 configurations, return to Step 1.
