18
English
buttons on
front panel
DVD system’s
display panel
Getting Started
Step 1: Inserting batteries
into the remote
control
1
3
2
1 Open the battery compartment.
2 Insert two batteries type R06 or AA,
following the indications (+-) inside
the compartment.
3 Close the cover.
Using the remote control to
operate the system
1 Aim the remote control
directly at the remote
sensor (iR) on the front
panel.
2 Select the source you wish
to control by pressing one
of the source select buttons
on the remote control (for
example TV/AV, TUNER.)
3 Then select the desired
function (for example ÉÅ,
S,
T).
CAUTION!
– Remove batteries if they are
exhausted or if the remote is not to
be used for a long time.
– Do not use old and new or
different types of batteries in
combination.
– Batteries contain chemical
substances, so they should be
disposed of properly.
STANDBY-ON
iR SENSOR
DISC 1
DISC 2
DISC 3
DISC 4
DISC 5
DISC 1 DISC 2 DISC 3
OPEN•CLOSE
123
456
789
0
REPEATREPEATDISC SKIP
DISC MENU
PROGRAM
SYSTEM MENU
SEATING ZOOM
PREV NEXT
SURR.
SOUND
VOL
OK
TV/AV
DISC/
MEDIA
TUNER
AUX/DI
STOP PLAY/PAUSE
Step 2: Setting the clock
The clock can be set in either 12-hour or
24-hour mode ("12:00 AM" or "00:00"
for example).
CLOCK•TIMER
CLOCK•TIMER
13:38
SELECT CLOCK OR
CLOCK
SEARCH
01:38 PM
PROG
13:38
CLOCK•TIMER
2
3
5
4
6
1 Press STANDBY ON to switch on the
DVD system.
2 Press and hold CLOCK•TIMER until
"SELECT CLOCK OR TIMER" appears.
3 Press T (if necessary) to change the
display to "CLOCK", then press
CLOCK•TIMER again to confirm.
4 Press S / T to set the minutes and
hours.
To increase the speed, hold down
S or T.
➜The changes in minutes will roll over
to the hours.
5 Press PROG to change between 12-hour
and 24-hour clock mode.
6 Press CLOCK•TIMER again to store
the setting.
➜The clock will start working.
To view the clock time in any active
mode
● Press CLOCK•TIMER.
➜The clock will display for a few seconds.
Helpful Hints:
– If the DVD system is disconnected from the
power supply, it will erase the clock setting.
– If you do not press any buttons within
90 seconds, the system will exit clock
setting mode.
