Position the Polar S1 Foot Pod
Install Foot Pod Battery
Before using the foot pod* for the first time, insert the battery (included in the product package).
1. Undo the flap and detach the foot pod from the fork.
2. Remove the black top cover by lifting it with the front edge of the fork (see picture 1).
3. Open the battery cover carefully. Pull out the battery case (see picture 2). Insert the battery (AAA) inside
the battery case.
4. Insert the battery case back inside the cover. Make sure that the case slides into the sensor grooves. Be
careful not to touch the switch on the foot pod* while sliding the battery case.
5. Make sure the sealing ring is in the groove, to ensure water resistance. Close the battery cover and place
the black top cover on the foot pod. Make sure it is secured.
6. The green light should start to flash after you press and hold the red button on the foot pod. Press and
hold the red button again to turn the foot pod off.
7. The battery should be properly disposed of according to local regulations.
Attach Foot Pod on Shoe
To measure speed/pace and distance accurately, make sure the foot pod is correctly positioned.
1. Undo the flap and detach the foot pod from the fork.
2. Loosen your shoelaces and place the fork underneath them, on top of the tongue of the shoe. Tighten the
laces.
3. Fit the front part of the foot pod (closest to the red button) to the fork and press from the rear end.
Fasten the flap. Make sure the foot pod does not move and is aligned with your foot. The more secure the
sensor, the more accurately speed and distance are measured.
4. Turn the foot pod on before exercising. Press and hold the red button on the foot pod until the green light
starts flashing.
5. After exercising, turn the foot pod off by pressing and holding the red button until the green light
switches off.
Optional calibration of the foot pod can improve the accuracy of speed, pace and distance measurements. For
further information, see Calibrate the Foot Pod.
ENGLISH
Prepare For Training 9
