Chapter 18 –
Appendix B: Telnet/Terminal Commands
18-6
Network Service
Key in the following commands after the prompt "#" to set network
configurations:
"set {lan1 | lan2} ip {dhcp | static <ip> netmask <mask> gw <gateway>}" -
set the IP address for LAN 1 or LAN 2 interface.
"set {lan1 | lan2} speed {auto | 1000 | 100 full | 100 half | 10 full|10 half}" -
set the connection features for the LAN 1 or LAN2 interface.
Network Setting Parameters – LAN Interface IP Address
dhcp
Automatically gets the address information through the DHCP
server.
static
Specifies the static IP address information -
IP: IP address of the network port
mask: subnet mask of the network port
gateway: gateway address of the network port
Network Setting Parameters – LAN Interface Connection Rate
Parameter Description
auto Auto negotiation mode
1000 1000Mbps
100 full 100Mbps full duplex
100 half 100Mbps half duplex
[Example 1] Set the IP address of the LAN1 interface to 172.21.103.29, subnet
mask to 255.255.255.0, and the gateway address to 172.21.103.254:
