189Preparing for a Videoconference Using SIP
Chapter 9: Videoconference Using SIP
Preparing for a Videoconference Using
SIP
Notes on installing the SIP software
• You cannot install the software if the write-protect tab on the “Memory
Stick” in which the SIP software is stored is set to “LOCK”.
• Once the SIP software is installed in the Communication Terminal, the
software will not be used again.
• You cannot install the SIP software which is copied to another “Memory
Stick” with a computer, etc.
1 Set the power switch on the right side of the Communication Terminal to
the off position (
a).
2 Insert the “Memory Stick” containing the PCSA SP1 SIP software into the
Memory Stick slot.
Insert the “Memory Stick” in the direction of the arrow with the mark facing
upward.
3 Set the power switch on the right side of the Communication Terminal to
the on position (
@).
The SIP software is installed in the Communication Terminal.
Installing the SIP Software
PCSA-SP1 SIP software
