1
OOV
Pump
Only - 765-300
11
OV
Pump
Only - 765-500
220V
Pump
Only
...
765-503
1 00 V
Complete
- 765-31 0
11
0 V
Complete
...
765-51 0
220V
Complete-
765-510
Motor
Paint Filter
Figure 1
General
Repair &
rvice Notes:
WARNING: Before proceeding, follow the Pressure
Relief Procedure outlined on Page
5.
Additionally,
follow all
other warnings
to
reduce the risk
of
an
injection injury, injury from moving parts
or
electric
shock. Always unplug the sprayer before servicing!
The following tools are needed when repairing this
sprayer:
Phillips Screwdriver
Needle Nose Pliers
Adjustable· Wrench
Rubber
Mallet
Flat-blade Screwdriver
1/2
11
Open End Wrench
3/8
11
AIIen Wrench
5/16~'
Allen Wrench
1/4
11
Allen Wrench
3/16
11
Allen Wrench
1/8
11
Allen Wrench
~.
Befo~e
repairing any part of the sprayer, read the
mstruct1ons carefully, including all warnings.
2. When disconnecting wires, use needle nose pliers to
separate mating connectors.
3
Pressure Control
Add P
.S.l.
Here
(Piston
Seal
lubricant)
Fluid Section
CAUTION:
Never pull
on
a wire
to
disconnect
it.
Pulling on a wire could loosen the connector from the
wire.
3.
Test your repair before regular operation of the sprayer
to be sure that the problem is corrected.
If the sprayer
does not operate properly, review the repair procedure to
determine if everything was done correctly. Refer to the
Troubleshooting Charts
to
help identify other possible
problems.
4. Make certain that the service area is well ventilated in
case solvents are used during cleaning. Always wear
protective eyewear
while servicing. Additional protective
equipment may be required depending on
th~
type of
cleaning solvent. Always contact the
supplie·r of solvents
for recommendations.
5.
If you have any further questions concerning your
TITAN Airless Sprayer, call TITAN Customer Service
Department at
1-SOQ-526-5362.
