Greensmaster 3320/3420Page 7 -- 22Chassis
Cutting Unit Suspension Assembly
1. Suspension assembly (3 used)
2. Flange screw (3 per suspension)
3. Basket
4. Clevis pin (3 used)
5. Cotter pin (3 used)
6. Washer (3 used)
7. LH spring retainer (3 used)
8. Lift cylinder
9. RH stabilizer spring (3 used)
10. LH stabilizer spring (3 used)
11. Spacer (6 used)
12. Cap screw (6 used)
13. Flange nut (6 used)
14. Flange head screw (6 used)
15. RH spring retainer (3 used)
16. Socket head screw (6 used)
17. Cable bracket
18. Cable bracket
19. Washer head screw (4 used)
20. Cable bracket
21. Cable bracket (2 used)
Figure 19
FRONT
RIGHT
55 to 60 ft--lb
(75to81N--m)
6
4
1
3
2
5
9
10
13
14
7
11
12
15
8
16
17
18
19
20
16
19
21
85 to 11 5 in--lb
(9.6 to 12.9 N--m)
85 to 11 5 in--lb
(9.6 to 12.9 N--m)
NOTE: Three (3) identical cutting unit suspension as-
semblies are usedon Greensmaster TriFlex Hybrid ma-
chines. The cutting unit attaches to the crossarm
assembly which isattached tothefront ofthecuttingunit
suspension assembly. The crossarm assembly can be
serviced with the suspension assembly attached to the
machine (see Cutting Unit Suspension Crossarm As-
sembly in this section).
Removal (Fig. 19)
1. Parkmachine ona levelsurface, engagethe parking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
