Reelmaster 6500-D/6700-DHydraulic System Page 4 - 52
Change Hydraulic Fluid
Change hydraulic fluid after every 800 operating hours,
in normal conditions. If fluid becomes contaminated,
contactyourlocalTOROdistributorbecause thesystem
mustbeflushed. Contaminatedfluid looksmilky orblack
when compared to clean oil.
1. Turn engine off and raise hood.
2. Remove drain plug from bottom of reservoir and let
hydraulic fluid flow into drainpan (Fig. 25). R einstall and
tighten plug when hydraulic fluid stops draining.
IMPORTANT: Use only hydraulic fluids specified.
Other fluids could cause system damage.
3. Fill reservoir with approximately 8.5 gallons (32 L) of
hydraulic fluid. Refer to Checking Hydraulic Fluid.
4. Install reservoir cap (Fig. 26). Start engine and use
all hydraulic controls to distribute hydraulic fluid
throughout the system. Also check for leaks. Then stop
the engine.
5. Check level of fluid and add enough to raise level to
FULL mark on dipstick. DO NOT OVER FILL.
Figure 25
1. Drain Plug
1
1. Hydraulic Reservoir Cap
Figure 26
1
