Inspect backstop for wear before and after
each use. Discontinue use if backstop shows
signs of failure or causes ricochet. Always
place backstop in a location that is safe should
the backstop fail. Think of what you might hit if
you miss the target.
• Put the airgun „ON SAFE“ as described
(see chap. 2.1
"Handling the safety").
• Pull back the bolt lever and then the rotary magazine retainer slide
(illustration 4.a) to be able to remove the rotary magazine.
• Remove the rotary magazine (illustration 4.b).
• If there is a pellet in the barrel, remove it with a cleaning brush or
proceed as described in chapter
"Jams".
• Do not try to shoot a used pellet. It might damage the rotary magazine
and the barrel.
• Remove the pellets from the rotary magazine by pressing with a
thin, blunt object.
• Make sure the airgun is completely unloaded.
• Put the empty rotary magazine back into the airgun.
• Push the bolt lever forward.
• Push the rotary magazine retainer slide forward.
WARNING:
When removing any pellet from the barrel with
a cleaning brush, place the rifle horizontally
(see chapter “Jams”). Do not hold the airgun
in a vertical position, as the pellet could fall
into the mechanism and cause damage.
WARNING:
Never use sharp metal objects to remove
pellets from the rotary magazine or the airgun.
Any damage to the rotary magazine or the
barrel could cause faulty operation.
Make sure the airgun‘s safety is „ON SAFE“. Insert a compressed air
cylinder and load the airgun as described. Make sure that your target
is safe before shooting.
WARNING:
Make sure that the airgun always points in
a safe direction. Never point at people or
animals. Always handle the airgun as if it were
loaded and ready to fire.
WARNING:
Due to this airgun’s high shooting capacity,
take particular care and caution in choosing
a safe target. Only choose targets that cannot
be pierced and that do not have a hard
surface that can cause ricochets. Never shoot
at liquid surfaces.
• Hold the airgun pointing in a safe direction.
• Put the safety "OFF SAFE" and uncock by pulling the trigger
and making a blank shot.
• Then engage back the safety.
UNLOADING THE RIFLE
2.5
POINT AND SHOOT SAFELY
2.6
