Xerox
®
DocuMate
®
4760
User’s Guide
185
Replacing the Rollers
Frequent paper jams are a symptom of a worn roller assembly. A worn roller can cause documents to feed in skewed
at an angle, or multiple pages to feed at the same time. A worn roller should be replaced to avoid damage to the
scanner’s internal parts. Before replacing the roller you should clean it as excessive dust on the roller will make it
appear worn and smooth. You cannot properly diagnose a worn roller until you have cleaned it.
When replacing the rollers described in this section, you should replace all of the rollers at the same time. Do not
replace just one roller and not the other.
Turn off the scanner power then unplug the power cord from the scanner. Pull the cover release handle and open the
scanner.
When you are done replacing the rollers, close the scanner carefully pressing down on both sides of the cover until it
locks in place. Do not slam down the cover.
Separation roller
1. Lift the ADF cover release, on the top of the scanner, to open the Automatic Document Feeder cover. The roller
module and housing are located in the underside of the ADF cover.
2. Grab the top of the roller housing, just beneath the ADF cover release.
