Filter
Top Products
49-EN
01GB06IVAW205R.fm
ALPINE IVA-W205R 68-08564Z42-A (EN)
• This adjustment is effective when the setting of the centre speaker is
SMALL or LARGE in the speaker setup settings.
• “REAR FILL” function:
Depending on the input signals, the sound may only be output from
the front speakers. In this case, the “REAR FILL” function can be
used to output signals from the rear speakers as well.
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is cancelled if the Decode mode is switched.
• This adjustment is ineffective when the speaker is set CENTER to
OFF in “Setting the Speakers” (page 42).
• This function only works with two-channel signals. This operation is
ineffective when 5.1-channel DTS or Dolby Digital signals are input.
• If the setting of REAR FILL is made when REAR MIX is ON, sound is
unchanged in the rear fill setting because REAR MIX is given priority
during 2 channel decoder other than linear PCM.
• For linear PCM signals, the voice is output from the rear speaker
regardless of the REAR FILL and REAR MIX setting.
• Touching [RETURN] will return to the previous screen.
Linear PCM Setting
The output when playing discs recorded in linear PCM can be set to 2 or
3 channels.
1
Check that Defeat mode is off.
2
Touch [SETUP] on the main source screen.
The SETUP selection screen appears.
3
Touch [AUDIO].
The AUDIO SETUP screen will appear.
4
Touch [] of A.PROC.
The A.PROCESSOR list screen appears.
5
Touch [] or [] of PCM MODE to select 2 CH or
3 CH.
• This adjustment is ineffective when the speaker is set CENTER to
OFF in “Setting the Speakers” (page 42).
Switching the Navigation Screen
(Optional)
If an optional Alpine Navigation System is connected to the
IVA-W205R/IVA-W202R, the Navigation screen can be displayed on
this unit.
1
Touch [SOURCE] on the main source screen.
The source screen appears on the display.
2
Touch [NAV.].
The Navigation screen is displayed.
The operation is possible with the supplied navigation
remote control.
For navigation operation, refer to the Owner’s Manual of the
Navigation.
• Use the “Setting the VISUAL Soft Button” function (page 37), to
select “Nav.”. The navigation mode becomes directly activated using
the VISUAL Soft Button.
• If the Navigation mode menu is not displayed on the main menu
screen, set NAV. IN to ON in “Setting the Navigation Mode”
(page 36).
• When the Navigation System is on, the audio and visual navigation
cuts in.
Portable Navigation System Operation
(Optional)
An optional Alpine Portable Navigation System is controllable from the
unit. For details on operation, refer to the Owner’s Manual of the
Portable Navigation.
About dockable BLACKBIRD series or Portable Navigation devices
with this unit:
• Docking to the PMD-B100 is not possible.
• For information on docking a portable navigation to the unit, consult
your Alpine dealer.
1
Press on the unit.
The unit changes to the EJECT/TILT screen.
2
Touch [OPEN].
The movable monitor will open.
2 CH: 2 ch output (L/R)
3 CH: 3 ch output (L/R/CENTER)
Navigation System
(Optional)
An external navigation system and portable navigation cannot
be connected at the same time.
If the Built-in Dock is used for IVA-W205R
68-08564Z42-A_F.book Page 49 Wednesday, January 24, 2007 2:26 PM