Alpine CDA-9885 Car Stereo System User Manual


 
32-EN
01GB05CDA9885.fm
ALPINE CDA-9885 68-08564Z14-A (EN)
Protective circuit is activated due to high temperature.
- The indication will disappear when the temperature returns to
normal operating range.
No CD is inserted.
- Insert a CD.
Although a disc is inserted, “No Disc” is displayed and the unit
does not start to play or eject the disc.
- Remove the disc by following these steps:
Press the button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
Mechanism error.
1) Press the button and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press the
button again.
If the error indication still does not turn off after pressing the
button for a few times, consult your Alpine dealer.
When “Error” is displayed:
If the disc cannot be ejected by pressing , press the RESET switch
(refer to page 7) and press again.
If the disc still cannot be ejected, consult your Alpine dealer.
A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
Protective circuit is activated due to high temperature.
- The indication will disappear when the temperature returns to
normal operating range.
Malfunction in the CD Changer.
-
Consult your Alpine dealer. Press the magazine eject button and
pull out the magazine.
Check the indication. Insert the magazine again.
If the magazine cannot be pulled out, consult your Alpine
dealer.
Magazine ejection not possible.
- Press the magazine eject button. If the magazine does not eject,
consult your Alpine dealer.
A disc is left inside the CD Changer.
- Press the eject button to activate the eject function. When the
CD Changer finishes the eject function, insert an empty CD
magazine into the CD Changer to receive the disc left inside
the CD Changer.
No magazine is loaded into the CD Changer.
- Insert a magazine.
No indicated disc.
- Choose another disc.
The XM or SIRIUS antenna is not connected to the XM or
SIRIUS radio module.
- Check whether the XM or SIRIUS antenna cable is attached
securely to the XM or SIRIUS radio module.
Radio is being updated with latest encryption code.
- Wait until encryption code is being updated. Channels 0 and 1
should function normally.
XM or SIRIUS signal is too weak at the current location.
- Wait until the car reaches a location with a stronger signal.
Radio is acquiring audio or program information.
- Wait until the radio has received the information.
The channel currently selected has stopped broadcasting.
- Select another channel.
Indication for CD Player
Indication for CD Changer
Indication for SAT Receiver Mode
(SIRIUS mode)
(XM mode)
(SIRIUS mode)
(XM mode)
01GB00CDA9885.book Page 32 Friday, November 17, 2006 7:31 PM