Filter
Top Products
6-EN
Due to the high power output of the MRV-F900, considerable heat is produced when the
amplifier is in operation. For this reason, the amplifier should be mounted in a location which will
allow for free circulation of air, such as inside the trunk. For alternate installation locations,
please contact your authorized Alpine dealer.
1. Using the amplifier as a template, mark the four screw locations.
2. Make sure there are no objects behind the surface that may become damaged during drilling.
3. Drill the screw holes.
4. Position the MRV-F900 over the screw holes, and secure with four self-tapping screws.
NOTE:
To securely connect the ground lead, use an already installed screw on the metal part of the
vehicle (marked (★)). Be sure this is a good ground by checking continuity to the battery (–)
terminal. As much as possible connect all equipment to the same ground point. These proce-
dures will help eliminate noise.
1
Self-Tapping Screws (M4 x 20)
2
Ground Lead
3
Chassis
4
Holes
Installation
★
3
2
1
4
Fig. 1